Cobra Accessories

4 Foot Linear Full Base

Accessory for Cobra Cutting Unit:  Cuts small areas of linear brick or cobblestone without the need to anchor to the concrete. 

4 Foot Linear Tracking Bar

When cutting large areas of linear brick or cobblestone, connect multiple sections together with dowel pins to achieve desired length.

Center Pivot for Cobra

Use two or more center pivots to weave circular brick patterns together. Machined from solid aluminum. Complete with indexing pin, star knob and smooth rotating ball bearing.

Circular Brick Cutting Kit for Cobra or Lil Beaver

These parts were used in a demo - covered under Full Warranty Kit includes everything needed to attach to Super Compact, Cobra or Lil Beaver to cut circular brick. Primary Connecting Bar, 1-28" Connecting Bar, 1-Center Pivot - Connecting Bar Screws and...

Connecting Bar Screws

Special under-cut heads 1/4-20 UC. Used to attach connecting bars together. These screws are NOT standard screws. Use of any other type of screw will result in a loose fit between the bars. Bag of 50.

Connecting Bar Support Wheel

Helps prevent connecting bar sag. Recommended when extending the connecting bar beyond 16 feet.

Dynamic Directional Omni Wheels

Dynamic wheels allow the tool to move freely in any direction. Typically used for cutting small radius circles and arcs when attached to a center pivot. Kit includes (8) wheels, (4) axles and hex wrench. Compatible with Mongoose 411, Mongoose Air and...

Linear Carriage

Carriage glides on linear rails for smooth cuts. Used for linear designs such as straight brick, offset tile, block and cobblestone.

Narrow Wheel Kit

Used for track-free engraving of free form curves and shapes, or for cutting small radius circles and arcs when attached to a center pivot. Kit includes (4) wheels, (4) axles and hex wrench. Compatible with Mongoose X, Mongoose 3, Mongoose 411, Mongoose...

Non-Marking Wheel Kit

Specifically designed for cutting overlayments, micro-toppings and other surfaces which tend to mark easily. Sealed bearings. Fits SawKart, Mongoose X, Mongoose 3, Mongoose 411, Mongoose Air, Super Compact, Little Beaver and Cobra. Set of 4.

Primary Connecting Bar Assembly

Attaches the Super Compact to the tracking systems. Includes Clamp Block, Stabilizer Assembly, Star Knob, 9/64" T-Handle, 4" and 8" Spacer.

Rigid Pointer System (RPS)

Cobra Rigid Pointer System - Facilitates quicker brick end (head joint) cutting. Attaches to plunger/pointer blocks on all models of Super Compact/Cobra. Replacement or up-grade for your engraver.