





















Liquid Nebula Metallic Epoxy Pigment for 3 Gallon KIt
Why limit your colors to this planet?
With Liquid Nebula, you can choose from the color palette of the gods…Galactic, Ghost of Jupiter, Super Nova, Helix…20 outrageously beautiful metallic color additives for epoxy.
Made of millions of suspended reflective pigments, Liquid Nebula powder mixes into epoxy to give both residential and commercial spaces the high-end, ultra-modern look so popular today. Use a single color for elegance, or blend colors for a breathtaking effect.
Liquid Nebula offers infinite design possibilities based on color choice and application techniques. The result is a durable, glossy surface with the breathtaking depth of color found only in the cosmos.
Metallic pigment for Epoxy. Add one container of Liquid Nebula metallic pigment to 3 Gallons of Part A Epoxy (or until desired opacity is achieved).
MIXING
Base Coat: When mixing a base coat or Liquid Nebula Metallic pigments epoxy add the appropriate amount ofpigment into the resin (part “A”) and mix completely using a paint mixer on a low speed drill. When desired color is achieved follow the directions above for adding and mixing in the hardener (part ”B”). It is critical to have an exactly portioned mixture, which has been prepackaged for you to eliminate any guesswork or measuring. After combining the two components use a paint mixer on a low speed drill for 2 minutes to completely mix the components. Be careful to not whip air into the mixture, and be certain to scrape the sides and bottom of the can to combine all molecules. Incomplete mixing or an off balance mixture will result in a coating that will remain soft.
Liquid Nebula Metallic Coat: When possible, blend the Liquid Nebula Metallic pigment into the part A component of CR-531 Inside Epoxy 24 hours prior to job start. This soaking time will allow the full wetting of the pigments with the Part A resin, thus minimizing the appearance of clumped pigment and “comet tail” effects during epoxy movement. If unable to do that, when mixing the Liquid Nebula Metallic pigments shake the container of Liquid Nebula Metallic Pigment and empty the entire container into the resin (part “A”) 3 gallon kit of Concrete Resurrection Inside Epoxy. Be sure to get all of the pigment into the liquid and not onto the sides of the container. Once mixed completely add the hardener (part “B”). It is critical to have an exactly portioned mixture, which has been prepackaged for you to eliminate any guesswork or measuring.
Multiple colors can be applied for additional effects – be sure to not overwork or you will not see the two distinct colors.
***WARNING*** Use only Concrete Resurrection epoxy pigments.
Application Recommendations
BASE COAT: The base coat for Liquid Nebula can be applied at a rate of 3 to 8 mils thick, using a roller, squeegee or trowel within the usable pot life time frame, as well as the recommended temperature and relative humidity guidelines listed in the Technical Information section.
LIQUID NEBULA METALLIC: Spiked shoes are recommended throughout application. Pour contents out in a long trail for application. Liquid Nebula Metallic Epoxy can be spread with Notched squeegee or gauge (wider squeegee is recommended), Spread product evenly over area. Flatten the poured out trail into place, as it self-levels. Back roll with a 3/8” roller or mohair roller or smooth using a Magic Trowel, speed squeegee or loop roller. (rollers should be premium quality with phenolic core and 18” wide is recommended for larger areas)
Choose options





















